Blitzkrieg Components, Benelli, Beretta Chevron Front Sight, Tritium Dot Lumi Green

Benelli/Beretta Chevron Sight Post - Tritium Dot, Luminescent Green Stripe

Benelli/Beretta Chevron Sight Post - Tritium Dot, Luminescent Green Stripe

The Blitzkrieg Components Tritium Chevron Sight Post provides a bold, fast sight picture in any lighting environment. The bright Tritium Dot combined with green luminescent stripes provide a highly effective low-light capability as well as an eye-catching daylight sight picture.  The dual capability of tritium and glow paint provide superior visibility when going from daylight into darkness.  On this latest model, the Tritium Dot size/brightness has been increased and a thin green ring around the dot has been added.  Precision machined from one piece of billet 416 Stainless Steel for durability and precise fit on all Benelli and Beretta Tactical Shotguns.  The included Blitzkrieg Components height spacers enable 3 height levels for the front sight post ensuring proper zero on any Benelli shotgun with aperture sights as well as the Beretta 1301 tactical shotguns.  

Features

• Bold, Fast Sight Picture
• Tritium Dot with Luminescent Stripes for dual low-light capability
• Billet Machined 416 Stainless Steel Construction
• Black oxide matte black finish
• Chevron Shaped Sight Profile
• Elevation Spacers to properly fit all Benelli Shotguns with this type of sight

Fit: Blitzkrieg's New Elevation Spacer System allows one sight to fit all Benelli & Beretta Ghost Ring Sighted Shotguns (Benelli M4, M1014, Beretta 1301 Tactical, Benelli M1, M2 Tactical, M3 Tactical, Nova Tactical, Super Nova Tactical)

Parts Included:

• Chevron Sight Post
• 2 Elevation Spacers
• Lock Nut

Drop-In Installation: To install, simply unscrew the nut holding your factory sight post in place and remove it. Then using the lock nut supplied with the sight, install the new sight post in its place.  2 Steel Height Spacers are included to adjust sight height as needed by adding them to the bottom of the sight post.  For the short sight height that is typical on Benelli M4 and Beretta 1301, no spacer is needed to match factory sight height.  For other Benelli models that use a taller front sight, 2 spacers are used to match the factory sight height.  If you desire to have your sight tip be at exact center of our front sight hood, use 1 spacer.  For super easy installation, get one of our 5.5mm wrenches (sold separately). 

MADE IN THE USA